When plastic parts are placed ın a vibrating bowl feeder, the friction causes them to charge. The charged parts then can jump out of the bowl, stick to machine casing and other earth potentials or cause mısfeedıng.

By positioning a PULSElectronic Pulse DC bar above the vibrating bowl feeder, you will bathe the entire area ın ionised air removing any possibility of statıc being generated and removing the opportunity of Mısfeedıng, sticking and material misbehaviour.

When laminating or bonding two or more surfaces together, problems can arise when statıc charges can force the surfaces apart. If using an adhesive or weld tool, you require the surfaces to be flush and without creases or curls.

By passing the material after assembly under a charge bar (An earth or ground is required on the other side) you can bond the stack together for a short while. When bonding larger stacks, two charge bars are required (One either side of opposite polarity). This will hold the stack while the laminating process is complete.